3423-036 UNI-LINE

The 3433 Gard-Pak II Motor Protector Kits are designed to replace the MP13, MP23 (3423) or MP33 (3433) motor protectors which may have failed, been damaged, or are not operating correctly. The 3433 module is the latest in a series of functionally similar controls and utilizes the most advanced state of the art internal circuitry to rapidly and accurately recognize and react to temperature changes in the stator windings of a motor. The 3433 module utilizes a vibration-resistant enclosed relay which mechanically isolates the solid-state sensing network from the equipment control circuit. This mechanical relay has been used to replace the Triac circuit used in the earlier MP23 (3423) Series. The larger size of this relay necessitates a slightly higher profile on the 3433 than on the MP23. Caution should be exercised to ensure adequate clearance if the 3433 is being used to replace a MP23 module. The 3433 also has a second capacitor to prevent contactor chattering problems. This capacitor also provides protection against momentary "opens" or chatter caused by voltage spikes. The module assembly is bonded in epoxy to ensure that the unit is unaffected by vibration, moisture or other contaminants. The application of a 3433 module requires embedded sensors in the stator windings of a motor. Therefore, these kits can only be used in applications where a Robertshaw® motor protector was part of the original equipment, unless the stator is rewound with new sensors in place.3433-047 Manual reset model requires use of a remote momentary "on" switch (provided by customer) to reset module in the event of an over-temperature condition. Note: The contact resistance and lead resistance of this switch must not exceed 0.15 ohms